Recent content by m715kaiser

my buddy and I shoot a colt I bought mine bout 6 months before him. I found a good load that my gun liked.When he tried the loads in his new gun it did not like them.It took me weeks of playing with the depth and powder to find a load that both guns liked.So I guess they are all somewhat picky...

guys I will not go into the, to clean or not to clean, that is covered. But I do know for a fact that if your cleaning media is giving you a hard time in your unprimed clean cases that the small air compressor I use with a blow tip will clean the media completely out of the case in a hurry.

just bought a rem model 700 30/06 got me a set of weaver bases split ,had a leupold 4-12 that I took off my model 742 bdl thought i was in there. the bases were so wide that the scope would barely fit in mounts .no room for eye relief . who makes a solid base to fit the mod700 so that my...

thanks and thanks again

Does it still hold true when seating the bullet to seat it just deep enough so that it falls in and out of the chamber without sticking? thats how I load the 45acp is this the same with the high powered rifle?

K but this poor boy uses an rcbs single press. guess I will have to measure each one thanks for the info

Thanks for the info one more for ya will I have to trim after each time the case is fired? I know the 45acp is no comparison to the 30/06 but I have not had to trim the 45acp yet.

ok so what happens if i trim to just below the maximum case length instead of the trim to length? Just curious

Ok ive been reloading 45acp for a while.Decided to tackle my 30/06. My speer reloading book is not clear on when to measure and trim the case. I am using my once fired factory remmington brass. Do I measure the case length before full length resizing or after I have resized the case? Hope...