Recent content by MAGGUNS44

  1. M

    In honor of Dave McCracken: shotgun wear pics

    Love to see truly "well used" firearms as apposed to safe queens.
  2. M

    Selecting Bullet/Powder for .357 Mag used in 4" Revolver and Marlin 1894 Rifle

    I am a H 110 guy when using jacketed bullets, seem to give best all around results in several different guns.
  3. M

    brass

    Check new brass, I have had quiet a bit over spec. I think I hate the trimming part worse than any.
  4. M

    .223 rem on whitetail deer?

    Have had good luck with remington factory 55gr soft points out to two hundred yards with neck shots.
  5. M

    Any chance Ruger will ever make these again?

    The 22 mag is way underrated, how about a semi-auto pistol with a four and a half inch or five inch barrel.
  6. M

    Keep this in mind when the next election comes up

    Politicians work for themselves not us, what was ya'll thinking? We all have let them by with too much for too long, it seems as though they have no consequences for their betrayals!!!
  7. M

    Gunk on dies

    I was given a bunch of new Dillon dies that has sat in storage since 1995-1998. No rust at all but I would guess that the factory protective coating has hardened or gummed up and brake cleaner will not cut it. Any suggestions on what I could soak these dies in to get rid of this coating?
  8. M

    Stairs for a box house ??

    Thanks guys!! There will be a pause at each step, and I like the idea of the platform half-way up. He can climb it but the easier the better. It will also have handrails on both sides. Thanks
  9. M

    Stairs for a box house ??

    I am building some box houses that will be eight feet off of the ground, I need to put stairs on them instead of ladders to make it easier for a dissabled hunter. Is there some kind of formula for figuring out the angle you need for the stair risers? Thanks
  10. M

    Problems with sizing - need some advice

    Are you lubeing the inside of the neck? You possibly could be stretching the case as you pull the sizer button out of the case.
  11. M

    Tumbler media inside loaded cartridges?

    Very possible it was the lube you sprayed in the case necks. It will not hurt the bore but enough of it as stated earlier could cause pressures to jump drasticaly, the smaller the case the worse it would be.
  12. M

    Resizing .223 brass

    Too much lube on the shoulder and it will put a dent in it. You lube the inside of the case neck to help the sizer button slide in and out smoothly, it will help keep it from streching it so much.
  13. M

    .243 load questions (novice needs advice)

    AR2209 ? I do hope you are using a powder scale also and not just depending on the scoops.
  14. M

    Need help with naming another new bullet -

    #1 DRT (dead right there) #1 HEEEE Daddy
Back
Top