Recent content by micrometer

  1. M

    Drill rod sizes

    Please recommend the most useful drill rod diameters for gunsmith work. I'll most likely use them for sear, trigger, sight, barrel band... pins. Thanks for any recommendations. Mike
  2. M

    Stripped 10/22 receiver - question about tapping.

    Brownells I also can attest to the Brownell's oversized 6-48 tap as a solution.
  3. M

    Loc-Tite the trigger pin in 10/22?

    I peened both ends of my pins to slightly increase their diameter. The pins are snug in the receiver.
  4. M

    Sprfld 03 A3 diminished value

    I bought a sporterized 03 A3 that has a rear aperture sight installed. The rear dovetail has been ground down to provide vertical movement for the sight and the receiver has been drilled and tapped for the single sight screw.:mad: I want to mount a scope and have the receiver drilled/tapped...
See more
Back
Top