Recent content by SteveV

Thanks for that, I will take your advice. Steve

Hi all, I have a number of Winchester and Remington once used brass fired from my rifle that I want to reload. I read somewhere that they may not be identical re weight and dimensions and that this may be a problem for reloading. So I weighed the empty cases and the Winchester comes in at...

Thanks guys, :)

G'day all, Just wondering when I should trim my .308 cases, before or after I neck size them? I am using a basic Lee Loader, am just starting out ;) For trimming, I was going to buy the Lee Hand Case Trimmer. Will this be ok for the job? Thanks, Steve

Thanks Remo-99, will get some AR2206H I think. Steve.

Thank you so much Ridgerunner665, you beauty! Steve.

I have just purchased a box of the 110g vmax for .308 and am after load data from Hornady. Finding it very difficult to get my hands on the current Hornady reloading manual here in rural Australia. Wondering if someone can help, especially concerning the min OAL, powder types etc. Steve

Thanks all for the great feedback. Steve

Have read alot of good things regarding this bullet. Could I have some load suggestions for the .308 especially relating to OAL. Am in Australia so will probably be using ADI powders. All 110 gn load suggestions welcome, doesn't have be the Hornady. Ta, Steve.

Thanks Ants, will try that.

Hi all from Australia, Am about to start reloading for my Mossberg ATR .308 but am confused about setting up my Lee loader to give me the right seating depth. If I need an oal of around 2.8, what is the best way of adjusting the stop collar and lock nut to give me the right depth. Is it a...