Recent content by SureLok

I don’t have a seating adjustment that I am aware of.

I haven’t fired them, I’m not sure what to do with them. I’m using the brass cup. All RP brass. Using a T7 to seat. I have tried reseating but with about 25% success. Would they be safe to load and shoot? Or try to deprime and save the brass, or discard them and move on?

Yes RP brass

Has anyone run into this? About 6-8 out of a 100 won’t seat all the way down. This is SPP. They shoot fine for the ones that seat correctly. I have used two different priming systems. It seems a bit excessive.

The Hodgdon website now has Varget. $63 per #.

Have you tried the shell plate timing kit from Randall Bragg? What is this timing kit you speak of?

What powder?

What is in Dawn that causes cases to stick?

Then how short (in thousands) would be too short for say a .270 WIN? I have a dozen or so that I trimmed too short too.

I saw where one of the companies that produce media for wet tumbling claims that it is ok to wet tumble die sets that have rusted badly. Has anyone tried this? Would there be any damage to threading?

Does anyone have this scope or any experience with it. I am strongly considering this, at around $1,400. I don't see a lot of reviews out there though.

Thank You

Does anyone here have a Knight KP 1 rifle in 45-70? I was wondering if anyone that owned one might have a favorite load.