Recent content by USMACHINEGUN.COM

M-11,Mac-10, AK, AR we sell most replacement parts for all M-11 & Mac-10 SMG and even some for the semi autos. Also carry a few smg parts for AKs and M-16, mainly bolt assemblies or trigger groups. M-11 SMG Parts: http://www.usmachinegun.com/products.php?cat=10 Mac-10 SMG Parts...

dealer to dealer should only take a couple of weeks as it is typically faxed, not mailed. Ours have been two weeks or so but your dealer has to get on it and fax it, not sit on the paperwork.

they are both completely different guns with different calibers. Neither has a real practical use, one shoots a rifle cal and the other a pistol round. Here is a link to a tricked out MPA 9mm since the previous photos are both Kel Tec- http://www.usmachinegun.com/proddetail.php?prod=MPAU-0137...

Forward tri rail design we are the only company that makes a forward tri rail type of mount for semi auto and SMG Macs, Master Piece Arms and other clones. It allows you to slide on laser, light and anything that has a rail mount. Mac-10 & MPA .45 acp versions are $79.98...

the sizes are too close to make an adapter which is typically made one inside the other. One in front of the other add too much length to go into a suppressor and may cause baffle strikes. cut your barrel back and thread it 5/8x24.

Even if you drilled two holes in the rear of a semi auto receiver, the fire control parts, i.e. sear plate, hammer and especially the spacer in the rear are all in the way so there is no space to slide in a wire stock. If you have ever fired an M-11 SMG, you would realize how unsafe and...

Here is one our most popular billet stocks that folds as well: http://www.usmachinegun.com/proddetail.php?prod=MPA45-FSAD you wont find a good folding stock that is non AR for less than $200. You get what you pay for. The folding mechanism alone is $75. or so. contact me with any...

we have a lot of them with a thread protector. Its a clean look when finished: http://www.usmachinegun.com/proddetail.php?prod=BT-RM2

new custom stock to add a stock to the Draco you are going to drill and tap two holes to do it the easy and clean way. We just finished our modular stock that fits just like the Ace with the two holes and you can add the folding mechanism as well. you can see it here...

You can change it into a rifle but to reach the length, you have to permanently attach the muzzle brake or other device. Cannot just be threaded on. To go back to a rifle as was just mentioned, you have to file a form 2 or form 1 plus the stamp and its an SBR. Just got through our ATF inspection...

Threaded Ruger for suppressor If you need your Ruger barrel threaded for a suppressor, I just finished one for a customer and he is going with a tom bowers suppressor. I have attached some photos of the work on the gun if you are interested. I threaded the barrel and made a thread protector out...