Closest I could get, Merry Christmas!
http://www.anzioironworks.com/20MM-TAKE-DOWN-RIFLE.htm
I.....I......i want that a lot
Closest I could get, Merry Christmas!
http://www.anzioironworks.com/20MM-TAKE-DOWN-RIFLE.htm
Why not a fbsp? Such as a sierra prohunter? I have yet to find a gun that can't run a flat based spitzer? Boattail spitzers may not be so generous I grant you.....Laidler et al will tell you SMLEs and other variants were designed with a flat base bullet in mind. They will often keyhole with spitzers if the bore and chamber are in less than perfect condition.
I for one would love to see a rimless.357 Magnum, of course I'd also need an M1 carbine chambered for it.
22tcm or 22 hornet?I'd like that to, there really needs to be more mini actions.
ive wanted a small 22 centerfire, something real cheap to load. Between a 22mag and 223.
I like the tcm but don't know if the rifle will hold up, it's pretty much a big 22lr action.22tcm or 22 hornet?
This would be cool.I want the 17 WSM in a .224 bullet diameter.
I saw one. Didn't jump on it and it was going the next day. I really want one. I just don't know if ria is up to snuff on rifle accuracy.I like the tcm but don't know if the rifle will hold up, it's pretty much a big 22lr action.
The necks are real thin on the hornet, brass is not as cheap it once was.
I've seen some pretty good group, there getting over 2800 fps with the 40gr that's pretty dang good. The action from what I've read and see is on the cusp of being strong enough.I saw one. Didn't jump on it and it was going the next day. I really want one. I just don't know if ria is up to snuff on rifle accuracy.
a (minimally rifled)
A rimmed rifle cartridge or family for single shot (and double) rifles. I might prefer something between .243" and .277"
A belted revolver cartridge,
I say, old chap, would you rather have a .240 H&H or a .246 Purdey? Or jump clear up to the .275 H&H Magnum or the .275 Rigby No 2 Magnum. In between, the .256 Mannlicher (6.5x53.5R Dutch Mannlicher) was a popular sporting calibre in England at one time.
That would take some fancy extractor work. Just as well make a rimmed round with a barely adequate rim like new make drawn brass .45 Colt. Or just a .40 S&W or 10mm revolver with clips. I know that can be done on a six shot L frame, but I doubt it will get you a 7 shot N frame.
I wish to present the Two Ninty Niche.
Plastic case .22 LR that’s even cheaper than current brass offerings