And too pronounced; that's a Glock frown. Must have had a homebrew Dremel Special Ghunschmidt job.That doesn't look like the typical Glock smile, way too far forward.
You're suggesting annealing the head of a brass case? The part of the case that is specifically protected from being annealed since softening it will lead to catastrophic case failure? The one part of the case that every single annealing tool is deliberately designed to not anneal?Just anneal the brass and reload.
And too pronounced; that's a Glock frown. Must have had a homebrew Dremel Special Ghunschmidt job.
You're suggesting annealing the head of a brass case? The part of the case that is specifically protected from being annealed since softening it will lead to catastrophic case failure? The one part of the case that every single annealing tool is deliberately designed to not anneal?
Good idea there.
It's not like 40 SW brass is hard to come by.
When in doubt throw it out!