blackd24
Member
- Joined
- Feb 28, 2020
- Messages
- 375
I bought the improved primer catch from inline fabrication and it’s working great to catch all the spent primers. However, it is contacting the ram and making a squeezing noise. Obviously these are 3D printed and every press/3D printed catch is a little different, but should I just let it go? Sand it a little? Anyone else have this issue?
I was looking up the McDonald’s straw solution for the front end to direct all primers to the rear. I am having issues with them spitting out the front so I want to try this. The picture I saw was to cut the straw 2 inches, and then a little notch at one end. Is that supposed to go in the hole in the center of the ram?
I was looking up the McDonald’s straw solution for the front end to direct all primers to the rear. I am having issues with them spitting out the front so I want to try this. The picture I saw was to cut the straw 2 inches, and then a little notch at one end. Is that supposed to go in the hole in the center of the ram?