CaprockJim
Member
- Joined
- Jan 30, 2021
- Messages
- 13
Just got this revolver with the understanding that it had a broken trigger, which it indeed has, have a new one ordered. While disassembling, found that cylinder pin is very hard to extract, in fact had to tap it with a neoprene hammer to get it out. On examination, it appears the rear frame base pin hole is very slightly off center, causing binding of the cylinder pin. Jerry Kuhnhausen wrote that this is not too uncommon in replica guns. Any suggestions on the best way to deal with that?
Thanks,
Jim
Thanks,
Jim