Well DARN!

Status
Not open for further replies.
Pull a couple bullets and see if the case will chamber as it is. It kinda looks like there is still some swelling near the base, like it wasn’t resized completely.
 
As for the Max 9 it's amazing what you learn when you do a plunk test. Like the squib just past the chamber. Now it feeds like a champ. 3 full mags through it with no jam. Now I just need to figure out the P95 DC. Can we say idiot? I knew we could.

Captain Quack.
 
Can we say idiot? I knew we could.

No, we can't. Wait until you think you have your chambers all figured out, then buy a Kimber, or a couple others, that a lot of even factory ammo won't fit in and you get to start all over again. 9mm is the worst for this so you just have to get use to it.
 
I have one of these in 9mm and it has the tightest chamber I have ever encountered in a 9. I almost had to get an undersized die for it. I load so everything chambers in it and all is good.
 

Attachments

  • 084263B2-E955-4B8E-818C-65711A89867D.jpeg
    084263B2-E955-4B8E-818C-65711A89867D.jpeg
    180.4 KB · Views: 16
Status
Not open for further replies.
Back
Top