Search results for query: *

I also found that I had to run them thru a 9mm sizing die as the bases were expanded. I assume from a larger than normal chamber in my cz 52

I screwed the die down all the way and that seems to have taken care of the problem. Thanks much.

I raised the ram to the highest it would go and then screwed the die down until it just touched and then backed it off a half turn. I cannot get the case to go into the die any further as the ram is up as far as it will go.

I resized some 7.62x25 brass once fired cases and now they will not chamber. The case goes in but stops before being fully seated in the chamber. These were resized using dillon spray lube and RCBS sizing die. It looks to me like the problem is at the shoulder. There is a definite difference...