Search results for query: *

There are going to be holiday deals this time of year. If you find some you'd like to share I'm sure someone will benefit from the information. Thanks!

Does anyone have the link to the site where a fellow made a case prep center using a hand-held mixer in a wooden box? I was asked how the guy connected the cut-off beaters to the case prep tools and can't remember. BTW, I had it saved until I killed my old computer and lost about a...

ROCKS AGAIN!!! :D Expander/rod/decapping pin was damaged during use. Called RCBS, no problem, new rod with expander and extra decapping pins sent NO CHARGE! Just wanted to tell of their great service as a way of saying thanks. Mods please move to Reloading...my mistake. Thanks

I recently posted about priming problems on my Loadmaster but couldn't find the post to update so here is the update. I was having problems with cases not getting primed or primed sideways or upside down. This problem has plaqued me for weeks. What I found is pure operator error. I watched...

Just looking for suggestions on solving a problem with my Loadmaster. It worked fine, admittedly after some debugging, for loading 9mm. Then I switched over to 45acp. Out of 45 cases, 14 failed to prime, 4 seated the primers sideways and twice the primer pin wdged in the up position...

In an attempt to purchase reloading components at reduced prices I am attempting to find sources for over-runs or "seconds" to help keep the costs of reloading lower. Should good information to attain these components become available I'd like to share this information with all reloaders...

Hello, I am thinking of switching to a ceramic or stainless steel media for polishing brass and wondered if anyone else could give me some advice on best type, where to purchase and how to best use these products. Thanks!

First off I'm not a competition shooter but thought you folks could best help me out with a delimma. I want to know some of the better ways of marking magazines to keep from getting them mixed up with other peoples mags. Some people use paint but I don't want to end up with the same "dot" as...

Anyone know of an affordable tool for crimping primers? Not a $5K commercial unit... Just something for the average reloader? Wanted after having some primers seat extra "soft" in LC and FC cases JIC. (Or do I need to make one? :))