Search results for query: *

there are some people who say you cant hunt deer with anything less than a 30-06 (some may even say win mag) but this simply isnt true.. curious where you live where you cant get closer than 400 though

its no secret the 7.62x40WT is a lot more energetic than 300 blackout and able to push the same bullets at higher velocities.. the ONLY benefit to 300 blackout is it can use unmodified AR mags

i dont see anything wrong or frightful of it, its a break action.. so long as the action was designed to be strong enough to handle the forces it shouldnt be a problem.. just a single shot like many, if not most 50BMG rifles out there, it just uses an action thats a bit different that doesnt...

the 9x18 is higher pressured than the 380, wolf ammo is almost ALWAYS anemic no matter which caliber.. i think the hottest 9x18 ammo was the czech military ammo which i believe measured out to a chamber pressure of about 25kpsi.. i doubt anyones going to load up 9x18 ammo to these pressures from...

if you want a 30 cal, get 7.62x40WT, 300 blackout is just overhyped, 7.62x40WT has about 200fps on the blackout, can be loaded up with subsonics just the same, function in short barrels even better, and is also made with 223 brass to fit the AR-15 rifle and bolts 300 blackout just gets more...

nothing better than HSTs

unfortunately for 25-45 sharps the case mouth is so far forward you can only fit the shorter, lower weight bullets, not really the longer ones that realy allow for good performance.. as for 300 blackout, its overhyped, over-advertised ripoff of 300 whisper, if you want real performance in a 30...

uuh, dwell time is the length of time in which a gas system in a gas operated rifle is under pressure, non applicable to blowbacks.. what prevents the bolt from moving rearward before pressures drop to safe levels is the mass of the bolt, and only the mass of the bolt as ive pointed out earlier...

i'll have to check them out, i have no doubt they function well.. its the stamped/sheet metal construction that interests me but in a good way, i like the fact its able to use simple, economical techniques to achieve the same end goal as competing pistols.. i may just have to add one to my...

id rather pay a pit more and not have a cheap turkish knockoff

its only the most modular and most versatile due to an almost non stop decades long pandering to it.. most of the time when someone makes the claim the AR can be adapted to fire so many different cartridges its only because so many have been made to pander to its limitations, from 22lr...

bolt thrust is figured out by the surface area of the inside base of the cartridge multiplied by chamber pressures.. the pressure that pushes the bullet forward is also pushing the cartridge, as well as the bolt backwards, your locking lugs is what prevents the bolt from flying back through your...

sell it, buy more 308 ammo

for the cost of what it is youd like to do, and your desire to neck it down why dont you just buy a savage 10 in 6.5 creedmoor or 260 remington?.. the end result would be a rifle thats a tad shorter, a bit lighter, much easier to customize and work on that is ballistically identical to 6.5x55 in...

all these old eastern block 9x18 pistols seem to be underrated.. many are well made, very accurate, brutally reliable, and 9x18 has the capabilities of providing both adequate expansion and penetration putting them above and beyond .380 for self defense.. its why im replacing both my 44 special...

what do you think of that P-83? it looks like its made out of sheet metal

well we cant really be certain of that.. unfortunately my dog is too old to eat and find out

meh, machining will never be 100%, there are always variations in the milled part which is why machines are rating usually about 0.0001% accuracy.. that said, since not all surfaces will be perfectly matched nor will all lugs on the bolt take an equal amount of forces from the bolt thrust.. 3-4...

uuuh, my dog is bigger than that "elk"

those MOE grips look like they use a similar shape to the SAW grip, anyone use both before?