i have a rcbs fl dies. i put the shell holder in then run the ram up to the top an screwed the die in until it touched the shell holder then went in 1/4 turn.. like the inst said.. but i may need to go in a half turn...
thanks Brent
I just resized an loaded some 308 win lc brass.. after i reloaded my first one i tried it in my gun which is a howa 1500 an it was hard to close the bolt.. i checked the messurements with the factory load which close up fine.. an they were the same.. so wondering why im having problems with...
thanks Randy thats what i was looking for. i went to there website but didnt look at the video. was looking to print somthing but this works just as well.
thanks again
i seem to have misplace my die instructions. dummy me laminated all of them an now i cant remember where i put them. where can i go to find them an print them off.
thanks,Brent
I have a mossberg 835 ultra mag. I will not cycle all the time. Most of the time it is the last shell in the magazine. I am thinking that the spring maybe getting week. Is my thinking correct or could it be another problem.
Thanks Treerooster
I also started with this kit and really like it. Widener's has the kit or 82 bucks but its out of stock at the time. What ever press you to get just enjoy and be safe.
I have been debating on buying lee autoprime. Since i haved read these few post i will be purchasing a hand held priming tool. Thanks for the info here.
Brent
I usually go to the classifieds for deals then rifle country then wind up here on handloading. Looking for good tips and info on reloading. Which i usually do find.
Brent
I found the Lee Deluxe Turret kit at Widener's for $91.00. So I ordered it I have been using a single stage press. I am waiting for the big brown truck to pull up anytime. So i am ready to get it set up and working. I like the single stage press for rifle reloading. But not for large amounts of...
yea thats what i use in my 270 win 130grn accubonds. was thinking of loading up some 100grn hornady bullets. It calls for the IMR 4831 instead of the H4831. I just wanted to make sure they were not the same. did not really want to buy new powder for this load but if i need to i will. thanks for...
thanks for all the info. is the lower reciever the only part that has to be purchased through a FFL dealer? Would it be better to get the upper and lower halves for a first time buyer or buy part by part? Oh yea and thanks for the welcomes. This is a great site with great info. Thanks Brent
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.