Search results for query: *

No steps out of order. First tumble is to clean and polish brass. This happens to ALL of my brass before entering my dies. This is not to remove case lube. That was what the rag at the end of the process was for.

OK here is what I'm thinking now. First go around full length resize , trim to x die specs , debur , chamfer, and set x die. From then on. 1. tumble 2. dillon spray lube Into the progressive 1. X die to size 2. prime 3. charge 4. seat 5. FCD if desired Wipe remaining...

so does the case mouth chamfer remain intact after using the x die ?

Anyone tried this yet ? Looks interesting trim , chamfer inside and outside of case mouth in 1 swipe.

Good points. I have 2 kinds of brass pmc and LC. Each is segragated . Both were bought new and only shot through my rifle. Neither has crimped primers. Thinking this could work with the x die.

I have recently gotten into shooting an ar so I'll be needing to reload some 223. I've reloaded rifle cartridges on a single stage and pistol on a progressive machine for years. I have never reloaded for the ar. Due to volume and limited time it would be nice to load the 223 on the...