Search results for query: *

  1. K

    Failure to feed tip

    An often overlooked area that can contribute to failure to feed is the bolt face. My new Kimber would not feed consistently until I polished the bolt face with a fine flat stone and 1000 sand paper. Then, ever so slightly, removed the sharp edge on the firing pin hole. Now with top quality...
  2. K

    SIG E2 Grips on Standard P226

    Has anyone tried to put the new SIG SAUER E2 grip panels on a standard model P226? I have read that the new P226E2 has a smaller grip and I wonder if the panels will fit the standard pistol.
  3. K

    Will the Ruger Mark II magazine fit Mark III?

    Will the Ruger Mark II magazines fit the Mark III ? And will the 3s fit the 2s?
  4. K

    Marbles Tang Sight Install

    I read on another forum that your serial number could be on the side of the tang. You have to take the stock off to see it.
  5. K

    Marbles Tang Sight Install

    The serial number on the 1970's model 336 is right up next to the tang screw. Actually it would need a sight base about 1 1/2" long to clear the number.
  6. K

    Marbles Tang Sight Install

    I need a little help about a Marbles Tang sight. If I install the recommended Marbles Tang sight on my 1970 model Marlin 336, I will drill and tap a hole in the middle of the serial number. I can't do that. I will go to jail for altering the serial number of a firearm. It does not make sense...
Back
Top