I was considering lengthening the forcing cone of a 3 inch chambered 12 gauge Mossburg M-930 shotgun and was wondering if anyone that has done their chamber this way got any beneficial results from it?...and if so, were the patterns any better?..or the same?...also can any gunsmith do this job...
I have been loading 357 Mag loads for a while and seem to constantly run out of brass for it...but I have plenty of 38 Special brass. I noticed that some 357 loads have lots of room left for the bullet, so I dumped the load in a 38 Special casing...and had plenty of room left for the bullet...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.