I recently had a problem with my Dillon XL650 that caused some primers to seat sideways while loading 460 S&W. The problem has been fixed but it got me to wondering if it was possible to set off a primer by crushing it in the machine.
The problem was with the primer seater assembly. This is...
I recently worked up a load for 9mm following the data on Hodgdon.com (see below). I put 4.4 grains of HP-38 under a Remington Bullet 9mm (355 Diameter) 124 Grain Full Metal Jacket (Federal No. 100 primers, COL was 1.095). After test firing at the range I noticed the primers were seriously...
If you had a recipe for a 124gr RN with a full metal jacket but you were using a 124gr RN with a total metal jacket, what adjustments (if any) would you make to the load?
I have some IMR PB and Rainier 9mm 115gr plated HP bullets. As you probably know, Rainier states on their website that reloaders should use data for lead bullets. I have three manuals but none of them have a recipe for a lead HP.
The Hodgdon site has data for a lead RN.
Bullet Wt (Gr.) Mfg...
I just put a Leupold VX-III 2.5-8x32 scope on my S&W 460XVR. I took it the indoor range to macro adjust the scope. The range is only 25 yards but I got the scope adjusted so I was getting everything inside a four inch circle. Next step will be to go to the outdoor range and fine tune the scope...
As I was reading this article it sounded to me like something that The Onion might parody. But apparently this was actually said by Bloomberg.
"No one but a professional chef needs an entire collection of kitchen knives. Why was this person, who had a criminal record, able to buy kitchen...
For almost eight months my gun store was unable to get 460 S&W ammo from their supplier (Hornady 200 grain FTX). Everywhere I looked on-line was also out of stock.
Two days ago my gunshop says they will be getting 6 boxes in their next order. At the same time I get an e-mail alert from...
I picked up a box of range brass and noticed two different head stamps for Federal brass. One case has two dots on each side of the FC. The other case has no dots. Anyone know what the difference between the two cases is?
I am thinking about getting a pair of electronic ear muffs. Are they a reliable form of ear protection? What should I look for and what should I avoid?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.