Search results for query: *

I don't have any experience with AR-10's bolt carrier assembly, (lots with the AR-15), but could this also happen with a slightly longer than spec firing pin? All primers are impacted by the pin when the bolt is closing, but not enough to set them off, I would think a longer pin might have...

Thanks for all the replies, it's good to know the cases a little short won't hurt anything. Jasper, when I was trying to find an answer to this I came across a similar thread that said consistency is always the key to accuracy. My take on it was the rounds just won't group as tight as a batch...

Long explanation for a simple question...whoops. But thanks.

I realize this question has been answered a few times in the past, but I was hoping I could get a little more insight into actual safe measurements. I have about 20 rounds set aside with cases that are a little shorter than what Hornady cites in their manual, specificially the trim to length of...

I'm not sure if this is relevant for the OP, but I have done a lot of shipping/receiving for online orders and phone orders, and our prices and costs were much lower than anything I have found for anything in the firearm related market. Our base price for UPS ground was $6.95, $13.95 for second...

Drop in bolt... Dirty? Very much so, especially the bolt itself. Problematic? Only when you find a box of weaker 22 ammo (one brick of Remington caused the most problems for me, but Federal ran fine, as did CCI). If you are thinking about picking one up I wouldn't hesitate, I shoot mine whenever...

I actually went through the same problem with the same rifles, and I ended up with the SPS Tactical. A few things I appreciated about the Remington were all of the aftermarket options, the trigger (I couldn't handle the accutrigger's little tang you have to depress), and the Savage accustock...

So after reading this forum daily for the past three weeks (lots of great info) I think I may be able to finally contribute something worthy as I have had almost the same exact problem with a Bushmaster using UMC ammo. Surprisingly I was using Sig magazines that didn't feed the round all the way...