Search results for query: *

I know that the barrell on a Benelli MP 90 .32 s&w is press fit and needs to be removed by loosening the set screws and then drifting it out....but which way? Out the muzzle end or the breech? thanks

I have just made deal for .38 sp Clark Long Slide. I shot it yesterday and it is fine but the safety doesn't work. No problem on a bullseye gun but I was wondering if that came from Clark's shop like that or it is broken. I'll post photos after I get the gun and clean it up a bit.

Has anyone knowledge of Zanoletti o/u shotguns?

My Hammerli 208 sometimes fails to cock on the last round in the magazine, it loads but does not cock. I have tried it with different standard velocity ammunition and it occurs with several of the brands....CCI, Federal 711B, RWS Pistol match and Fiocchi. I suspect a weak spring but I'm not...

Is the frame on a Kimber Custon II identical to that on a 1911 Colt 1980?

U.S. tourists busted for Winnebago gun arsenal By Gerry Bellett, Vancouver Sun July 22, 2011 3:03 [...Removed Copyrighted Material...] http://www.ottawacitizen.com/travel/tourists+busted+Winnebago+arsenal/5141382/story.html

I recently started reloading .223 for a RRA Varmint Model (Wylde chamber) . The once fired Federal Brass all lack enough tension to hold the projectile after being Full length sized in new RCBS dies. Are the dies out of spec ( expander ball measures .224 but I don't have the most accurate...

Is there a significant difference in wear on the finish of handguns from different holster materials? Is leather better than synthetic ?

I've just reloaded some .338 Federal rounds and had to cull 22 cases because the bullet was loose after seating and crimping. These cases have been reloaded several times and started life as .308 Norma brass. Are they just worn out and need to be junked or is there some way of using them ?