Search results for query: *

A bit of a late tip to post but for other people needing help; The notches on the trigger pivot pin need to face DOWN. When I reassembled I had them facing up. The Locking block will go in but will not seat correctly and will damage the finish on the frame on the right inside.

I absolutely hate mechanics sometimes. You have to get in a angry mood almost to the point of not caring about the finish to get it in there. Then it just pops in. JUST POPS IN SOMEHOW. grrrrrr But from this I might make a video review with the little tips included. Thank you for your help MJ

Yeah thats one of two videos that I was using as a guide. I got the Safety Lever in and now I'm down to the locking insert and it is not going in right and giving me a headache. Was very easy to take out......

Does the tail go between the Sear and the Hammer Pivot Pin? And no there isn't a video that I have found will look into it.

Hello users of THR, New to the forum with a quick question. Was following a disassembly video for my new P226 and ran into a complication during reassembly. The model in the video was the standard P226R I believe while I have a newer P226 Extreme. The problem I ran into was the...