Thanks. Natchez still had AA2460 and I put it in cart and sealed deal. Went straight back because I had a feeling, yep.. it was OOS.
Hope I made the cut
-178S
Thanks- Not knocking just wanted to know if anyone has received any shipments from that time. Yea, I sent an email too a while back no response. Hey, if it comes in great- if not, oh well.
-178S
Are they answering the phone for you? Not me....
Anyone get their order from the mid Feb period when they said they had a large shipment of powder in stock?
Pretty close to just forgetting about it........
-178S
I use my Dillon 550B as a single stage press for rifle loads. When I started with 30-06 and using IMR-4064 for my Garand load, the powder did not meter well in the Dillon powder measure and it was jacking up the flow. Flake powder and Dillon measure are in conflict lol..
Bought a LnL powder...
No doubt. I stayed away from the primers at Brunos as I was OK there. The H335 was a little higher than normal but it was still OK. But now I found some BLC2 so if I get the H335 fine. If not, time to work up a new load.
-178S
I use the MTM ammo boxes. They hold up to 1.3K of bagged 223 bagged in Qty of 100. For pistol, I use same cans and store them in cheap card board boxes or old ammo boxes.
The biggest issue I have with the boxes is the older stuff is always on the bottom without constantly re-boxing. Always...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.