Search results for query: *

First of all, thank you for time. I appreciate any and all input on this, as I'm looking at a stage 2 folding AICS stock for a .308 SA 700. I'm 99% sure it'll work, but want to be absolutely sure before I take the plunge on the stock and see if there are any alternatives. I searched and found...

I'm getting into reloading and, in addition to researching for calibers I already own, am looking through for potentials to what would make an accurate and versatile "pet load." Allow me to explain. Though a novice to the hobby, I have always loved ballistics as a science and now that I have...

A few months back my dad and I were aligning a stubborn gas block on my lefty-piston AR. In the process, we managed to bend the upper on the strip just under the ejection port. We did not have a vice at the time, so we used leather and tape-wrapped wrench to bend it back. After a lot of elbow...

Good morning gentlemen. I'd appreciate some input on your craft. As of right now I am just an avid shooter with about 50 lbs of brass but am hoping that in time I will have the know-how and equipment to load my own cartridges. What I hope to gain from this thread are links to instruction...

Good evening, Gentlemen. I inherited a late 70's Ithaca 37 from my late grandmother a few years ago. I've never fired it, and only taken it down and cleaned it a few times. When I got it, everything seemed to be in good working order. However, the last time I reassembled it, the pump/slide...

I've looked around at a few cleaning threads, but none have quite satisfied me. Therefore, I'm starting my own. If I missed one in my search, please redirect me and I'll delete this one. I've been using hoppes 9 for a couple years now. At first when I was using to clean brand new guns it...

(I'm operating under the assumption it's best to make a separate thread for each different question I have concerning different weapons (for search purposes), but if y'all would prefer a less thread-more tangents in one thread approach let me know. :)) A few weeks ago my Stag M8L (the lefty...

(This is my first real post, so please be gentle. ;) If this has been covered, jut show me the link and I'll clean up.) So, I have this nagging problem with the rear trigger plate group screw and the front guard screw on my short-action, ADL synthetic .308. When I tighten them, the screws...