Search results for query: *

I know. It's like the hammer nose cut a groove in it. I'm not sure how that even happens. The gun has been heavily used. I've bought quite a few used pistols, mostly from guys who shot them a few times and became disinterested in BP, but this one has seen a lot of use.

Update on this project Since the gun functioned with a new cylinder and without any cylinder, I thought the original cylinder must be the problem. The original cylinder had some deep grooves cut in the shoulders. So I filed those down and lo and behold...it started holding at full cock. Plus...

Hellgate you can own this one for $150

It's always the same three chambers Trigger operates without a problem when the cylinder is not in the gun

Does anyone know if parts are available

What images could I post so you could get a better idea?

Picked up an E.N. Santa Barbara with plans to convert it to Bulldog fantasy gun. Over a couple of sessions I put over 60 rounds through it, broke it down and cleaned it each time and it performed without a hitch. After the last session, it now will only hold full cock over three chambers...

What is the purpose of the friction piece? Will removing it cause problems?

I have a 11-48, 28 ga. that will cycle heavy hunting loads. When I use light target loads it will not eject the shell. These are Winchester AA so not a low quality shell. I removed friction piece and it works fine (see attachment) My question is will removing this cause long term problems or...