My LNL (S/N 360xx) hub just broke. Purchased in early Dec 2011 from Cabelas and I've seen a few other posts from people who have similar S/N's with broken hubs.
LnL was setup for 9mm Luger and the shell plate was tight. The hub broke while extracting a case from the sizing die.
Looks...
Greetings
I'm using a 9mm Redding titanium carbide resizing die and the 'sharpish' edge on the die entrance is occasionally catching the case. I'm using a new LNL and have verified that the timing is correct on the shell holder. The cases don't catch too often but even 1:20 is a bit of a pain...
Greetings
Is it possible to do an FFL-FFL transfer of an 'old model' Ruger revolver where the purchaser (me) is a Ca resident and the seller is located in Az.
The particular OM I'm looking at was manufactured in 1968. The way I read some of the Ca regs it looks like this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.