Search results for query: *

Lubriplate SFL-0 Grease I use Lubriplate SFL-0 Grease on the rails of my semi-autos. Lubriplate grease has been well known for many years to be a fantastic firearm lubricant. Used by the military, it was issued for use on the M14 rifle. With tighter tolerances on newer firearms the SFL...

I've read several post on various forums discussing the finish on Glocks manufactured in the last year or so. They claim the finish is already starting to bloch, show excessive holster wear and even some rust around the rear sight base when carried using a IWB holster. My Glock 17 is 3 years...

I bought a SKKY CPX2 a couple of months ago. The first range trip it ran well, no failure to feed or failure to eject. Put 50 rounds through it, Perfecta and Freedom Munitions 115gr brass case. During cleaning I found the retainer that holds the recoil spring on the recoil spring guide rod had...

Gun: SCCY CPX-2 Purchased from Davidson’s on 11/23/2015 Took delivery on 12/02/2015 First day at the range: 12/6/2015 Recoil Spring Sub Assembly failed. The round retainer that holds the springs on the recoil rod broke. I found this during cleaning. 50 rounds were fired. 115 grain from...

The two pistols I rotate thru CC are Glock 17 and Kahr CT9. Almost a 1000 rounds thru each one and no failures of any kind. :)

Kahr CT9 no problems whatsoever I purchased my Kahr CT9 last summer. It has performed flawlessly. All 3 magazines have worked without any issues whatsoever. Round count to date is a little less then 1000. The pistol fits my hand very well and more important I can hit what I aim at. This is one...

I own a Glock 17 and Kahr CT9. My hands are average size and I find the Kahr CT9 fits much better. Target groups at 15 yards are tighter with the CT9 plus it seems to point naturally. I shoot the Glock 17 very well but I've had to work hard to do it. The D/A trigger on the CT9 is long but very...

Thanks for your input. At first I thought it was just a machining mark as the machining is rough to say the least. Using a high power magnifying glass I could see a very faint "V" type notch in the crack or seam. When I drug my finger nail across it, the nail would catch going in both direction...

I bought a new production Yugo M57 in 7.62*25 from Centerfire Systems last July and I've put 100 rounds of PPU ammo through it. The gun is being sent back for repairs already. What it does well: 1. It feeds and extracts properly. 2. The trigger is a bit heavy but smooth. 3. Overall, cycles...

I bought my Yugo M57 from Centerfire Systems last August. Since then I've run 100 rounds of PPU through it. The pistol cycles fine. What it won't do is hit on paper. At 10 yards it is hitting 6 to 10 inches low but does group there. It's not key-holing any rounds like it would if the bore was...