Search results for query: *

Thank you so much bds. And all you others too. I am going to check everything you have said and I will report back. Many thanks again, not much tech support here in South Africa :)

Ok, good on the screw. I am using the dies that the press came with. It is set up for 9mm Luger. My main problem is the ram pulling loose from the carrier. On the upstroke to seat the primer, the carrier is at the bottom, when you give the lever the press forward, the ram goes down further than...

I bought a Lee 1 000 almost 2 months ago. I have managed to produce exactly 78 rounds. Everything that can possibly go wrong has. I have developed such a hate for it that I want to smash it into a 1 000 pieces. I have totally given up. I have the powder measure working properly eventually, the...

Thanks a mill for the advice, going to try it out and let you know. have a good one.

Thanks guys, My problem is cases getting stuck in the resizing die on my Lee 1000 which does not have a carbide die.

Any reccomendations as to a product and best method to lube 9mm cases in volume?

It's a brand we have here in South Africa, it is mostly Lanolin. Perhaps I am not mixing it correctly

The hex bolt is tightened, I checked that out. It is a decapping and sizing die. Have I perhaps got it screwed in too far?

I finally have my pro 1000 producing some ammo. The only problem I still have is the decamping die. The case is getting stuck and as a result the ram comes off the shell plate carrier. It is not a carbide die. Can I lube the die itself? And if so will the dry Teflon be ok?