Search results for query: *

Everyone says H1000 and Reloader 22 but I had a pile of 4350 and 8133

The 68 and 68.5 were both ≈ 6” below point of aim whereas 69, 69.5, and 70gr were all ≈ 5” below. Now the 8133 all groups were a pretty uniform 5” below POA. I will also say the higher loads of 4350 were showing impressions of the ejector on the brass.

Goldie each of those groups pictured has the same point of aim and all shot off a lead sled. Any up and down in a group movement was from load consistency. The 68.5 of 4350 and the 79.5 of 8133 are looking like two good candidates. Someone on another forum suggested I do the Berger seating...

yeah I still have the target up and can measure the POA vs POI. I didn’t start chrono yet as I’m more worried about accuracy than speed. I do feel I was getting a bit higher pressure out of the 4350 vs the 8133.

Eventually move out to 1000+ looking for input on picking a charge, seating depth etc

I have a Remington 700 5r Gen 2 I’m using at 100yd Nosler brass Federal 215M primers Hornady 212gr Eld-X 3.606” COAL 0.020 off lands I tried developing a load using IMR 4350 because I have a ton but I did load a few with IMR 8133. The 8133 loads are definitely compressed. Where should I...

Does anybody know why they put GPS on all thermal scopes? Side question, I say all, but are there any thermal scopes that dont have GPS, WiFi, recording, etc.....?

I looked again at that listing that was linked, I can't find the original ebay listing, however that is the exact piece as the scratch on the right side behind the cylinder is the same.

It says that one was sold on ebay and this was bought from an estate, but I have no idea if serialization on these was a thing or if it was just a generic serial number. So maybe?

Well I do believe that is it. I wonder who made it or it’s value?

Oh, no there is no holes in the barrel. Did Colt even make props/blank guns?

What is a hold on the barrel?

So not sure if this is the right place but looking for help on a revolver my uncle picked up at auction today. Advertised and bought as Colt SAA .45LC and I'm looking it over for him and the barrel is plugged and has what looks discs halfway down the chambers in the cylinder. Barrel has Colt...

Thanks for the information guys. I may steal the idea with the block of wood.

Hi there, I was wondering if any of you knew any advantages of 1/2" vs 3/8" pillars for bedding a stock. Also should you use a 3rd pillar with a remington adl for the middle screw? Thank you.

You guys are awesome, I can't believe how much I learned asking that one question.

Haha I understood what you meant. I'm not going to send it away because I'm teaching myself the gunsmithing

Okay so the gun is functioning as intended, the timing is just a little loose, probably as it is so old. You guys have been a great help, thank you.

Yeah the spring doesn't look right but the way the crescent part of the latch is shaped it doesn't seem to be designed that it will let it go back up, even if I try and exert a little force on it back up it does not go. This is all a learning experience for me.

And with a full cock...