Search results for query: *

I have a Remington 700 5r Gen 2 I’m using at 100yd Nosler brass Federal 215M primers Hornady 212gr Eld-X 3.606” COAL 0.020 off lands I tried developing a load using IMR 4350 because I have a ton but I did load a few with IMR 8133. The 8133 loads are definitely compressed. Where should I...

Does anybody know why they put GPS on all thermal scopes? Side question, I say all, but are there any thermal scopes that dont have GPS, WiFi, recording, etc.....?

So not sure if this is the right place but looking for help on a revolver my uncle picked up at auction today. Advertised and bought as Colt SAA .45LC and I'm looking it over for him and the barrel is plugged and has what looks discs halfway down the chambers in the cylinder. Barrel has Colt...

Hi there, I was wondering if any of you knew any advantages of 1/2" vs 3/8" pillars for bedding a stock. Also should you use a 3rd pillar with a remington adl for the middle screw? Thank you.

I have an old Colt New Army that has the timing slightly off, when the hammer is fully cocked, the cylinder catch does not return up to lock the cylinder fully. Looking at the inner workings it does not seem like it is designed to allow it to return up when cocked. Is this by design or what? The...