Search results for query: *

One of these things is not like the other..... Same bullets, same box, but substantial difference in OAL and the width of the meplat. This is reeking havoc with my COAL:mad: I was going to post some pics but it looks like the forum now only allows linked images so I won't bother. (edit, I...

Has anyone tried this? I know this is an oddball powder but I'm curious about this. The burn rate characteristics are very close to Blue Dot which is a very good powder for .357mag. I have worked up .44mag loads with the same powder (3n38) but was unable to chrony the results.

So I know this is a little obscure hence why I posted it here. I have a MKVI in extremely good condition. At some point somebody turned down the cylinder to allow the use of .45acp brass in moon/half-moon clips. I worked up a light plinking load using Unique and 230gr MBC cast a few years...

So I was inspecting my carry ammo today after a range visit and to my surprise some of the rounds were visibly shorter than others. I pulled out the calipers and measured a COAL ranging from 1.082-1.115. The scary part was that I was able to shorten the COAL by squeezing a round between my...

So I am trying to work up an extra soft 9mm practice load for my recoil sensitive wife and for the introduction of new shooters. I was recently able to acquire a can of Bullseye. Since Bullseye is supposed to be great for light loads, I am hoping to have better results this time. My previous...

Pistol powders are still scarce in my area and I'm down to my last few grains of H110. I bought a can of 3n38 hoping it would be a little more versatile than it has proven to be so far. I know this stuff shines with heavy 9mm .40S&W loads. Has anyone tried to work up a .44mag target/practice...

Anyone have any good recipes for 165-172gr cast 30-30 win using reloader 15? I'm using Missouri Bullets #1 and will be loading for an 1892. Please note what end of the spectrum the load falls under (heavy or light) and whether it's referenced from a manual or worked up yourself. My manual...

So, I'm relatively new to this whole process but was finally able to get a proper shop and bench set up with all the necessary tools. Started with .38spl wadcutters, no problem. Next I tried .45acp 230gr lrn, once again relatively easy. However .380 is proving to be quite the PITA. Everything...