Search results for query: *

I looked around the internet and cannot find loads for the 223Rem (.224) with Hornady Vmax bullet with Benchmark powder. I have Varget, H335, Imr4895, H322 on hand. I would appreciate if those who have tried Varget/Benchmark to post loads. Should I use loads from the next weight in the lineup...

I finally got some H4895 powder. Going to load some reduced .243W loads for my son to shoot in his Ruger American Compact. Question I have is I read on Hodgdon website that I can take the max powder charge for a bullet that uses H4895 and use the 60% calculation of the max to find the reduced...

I am curious about adjusting scopes when sighting in. The Sightron rimfire scope how do you adjust this scope? I.E if I shoot bullseye and the bullet impact is 2" low and 2" left do I move the vertical adjustment to the UP arrow? Or is it the opposite by moving the vertical adjustment following...

I brought my Marlin 39a out of the grave. This is at least 35 years old and in almost pristine condition. I forgot completely how to take it apart since its been so long since I messed with a lever. I could not find the original manual so I download from the 'net. The doc I download is for a...

I will start off saying that I finally brought from my childhood home my Marlin 39a and recently bought a CA American LH 22RF. I read on the 'net that someone said for the CZ you need to use a smaller bore-size rod to clean the bolt gun. What are they referring to? Buying a rod smaller than...

I've always wonder *exactly* what is this? When setting up dies I set up by screwing down the die until it touches the shell holder when the shell holder is fully upward. And then I lower the shell holder and turn the die further down 1/8 to 1/4 and set the large nut. Why do they call this...

I recently installed Fed210 on 270W case and loaded H4831 powder but have not load the bullet. There is one thing I am thinking out loud. This brass was shot in the same rifle as previously and I resize this brass on my new Redding Turret and RCBS dies that I have used with same brass. I noticed...

Looking at the Speer #12 Reloading Manual in section covering the 6mm/243W it shows 85 Grain (part # 1213) reduce load of IMR 4198 of between 17.0 and 19.0 grains. My question with this is I have the Speer 100gr (part # 1220) and there is no reduced load listed. I was wondering if reduced...

New register and first post ... Bought a Ruger American Compact for my son. Doing a search for those who have reload and got good grouping for this rifle I came across the post by azbass and I tried to reply to his thread and error msg said the thread is more than 411 days old. Duh...I...