I was not wanting to wait for a package as some of the parts I ordered through the USPS (not just during Christmas) have taken up to 5 weeks to get here when it should have only been 3 or 4 days.
I have 4 stripped bolts I'm putting together and am duplicating the small parts out of stock I have...
I'm looking for the dimensions for the 10/22 Extractor Plunger.
I'm too cheap and unwilling to pay $6 a piece and shipping for a tiny little pin that I can make at home in 5 minutes and would greatly appreciate if someone could take the measurements for me.
It's a small stepped pin with 2...
I would think the type of action is a side issue.
When the .222 was developed in 1950, it was primarily a bolt/lever action cartridge, not gas operated semi-auto, so was the .223 when it was developed in 1957 as a small mid-western varmint cartridge, but until it was used as the test round for...
It's been a while since I called somebody out and pissed them off, but here we go.
They list 222 for both CFE 223 and CFE BLK, and 222 is a slightly shorter version of the 223 so the round fits the same bore and basic application.
Texas 10mm, Saying that "There's a DAMN good reason Hodgdon...
There needs to be an Iver Johnson thread.
I just picked one up and other than excessive barrel to cylinder gap, it looks decent for a cheaply made pocket gun of that era.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.