archangel2003
Member
- Joined
- Feb 6, 2015
- Messages
- 9
I'm looking for the dimensions for the 10/22 Extractor Plunger.
I'm too cheap and unwilling to pay $6 a piece and shipping for a tiny little pin that I can make at home in 5 minutes and would greatly appreciate if someone could take the measurements for me.
It's a small stepped pin with 2 diameters and a length for each, and also, could I also get the depth and diameter of the hole it goes into to verify mine is the same?
I'm willing to be I'm not the only one who keeps spares of small parts like these.
I'm building one from scratch, will probably loose it boating, but before I do I'd like to finish it first.
I'm too cheap and unwilling to pay $6 a piece and shipping for a tiny little pin that I can make at home in 5 minutes and would greatly appreciate if someone could take the measurements for me.
It's a small stepped pin with 2 diameters and a length for each, and also, could I also get the depth and diameter of the hole it goes into to verify mine is the same?
I'm willing to be I'm not the only one who keeps spares of small parts like these.
I'm building one from scratch, will probably loose it boating, but before I do I'd like to finish it first.