Search results for query: *

I may be wrong, but glocks are not under any tension. The firing pin is drawn back and released when the trigger is pulled. But when at rest, under no tension. Not trying to disagree, but I think that's how they work. :)

Thank for the advice (and the pokes, Old Fuff). I'll see how she does in a few hours.

I just bought a new full-size Kimber Raptor II at the Pasadena gunshow (thanks for all the advice to check out AJC, the had awesome prices). I was reading through the owners manual and it said to break it in with factory 230 gr, fmj. Does anyone know if it matters wether I use that or my own...

Howdy, I will be taking a roadtrip from Texas to Florida in a few days. I usually keep my Rock River M-4 in the pickup. Round isn't chambered, but there's a full 30rd mag. I'd like to keep it that way on my trip. But I don't know the laws in Louisianna, Mississippi, Alabama, Georgia and...

Johnny, You're absolutely right, I'm really trying to do this with minimal cost. I am really interested in getting into reloading... REALLY interested!!! But I don't have the cash to acquire a reloader yet. These should be sufficient to hold me over until I get more funding.:D

I've only tried it with .38 spl so far. It was awesome.

Awesome responses so far, thanks a lot! I'm gonna try some of this stuff tomorrow.

I'm trying to figure out how I can remove a primer from a spent round and add a new primer... without a reloading set? It may sound like I know nothing about the subject, but that's just because I don't :D. Seriously though, someone had directions to make wax bullets the other day, I decided...

Anyone in Bryan/College Station want to go shooting?

My mistake... Kinda new to this site. Thanks for pointing that out though.

Howdy, I'm curious if anyone is in the Bryan/College Station area? Just lookin for someone to go shooting with.

Mousegun, I've often wanted to do this, but how much did it cost? I'm a college student, and the sad reality is that I am severely limited by my budget. Also, where did you order the components form (frame, slide, barrel, springs)? Good job thought, try to post us a pic.

No it is not sent to grenade launcher. The gas valve is set to semi-auto.

Doug I'm really interested in this, but don't really know how or exactly what you did. Can you elaborate for me, or if possible send me a picture? Thanks a lot.

one other important thing... The one thing I've noticed is that the gas tupe has the 'rod' inside of it. It seems like it doesn't pust through enough. It comes out the other side maybe 1 to 1 1/2 inches. But from inspecting the tube I would think it would come out more like 3 inches.

roscoe Recoil spring is good, no erosion, no crud.

Techno Thanks, I'm not to sure how to check for a leak in the system. I did clean both pistons very well.

Fairly certain. I took the time to learn all that I could about the rifle and it's operation before disassembling it. I've read four or five articles on how to do it and watched a video on it. From everything i've read/seen it is done correctly.

Just bought a Yugo SKS the other day. Cleaned it very well and got rid of all the nasty cosmoline. Took it to the range today and it fires, but won't cycle the next round, I have to do that by hand. The gas valve is in the 'on' positon (off to the side, not straight up). I've cleaned out the...

I just purchased a Yugo SKS on a whim. Compulsive purchase :biggrin: saw it for about $100 and had to have it. Anyway, this thing is COVERED in grease. I've cleaned most of it off with brake cleaner and a cloth. But what else do I have to do? Obviously clean the barrel. But what about...