I just won a .308MX and I know nothing about it. I'm not new to the gun world but this one has very little information about it. Cartradges of the World provided some history and a few loads: But what about dies? Can't find any: Ahything you might know would be appreciated. Thanks
I have no clue what a POF is and I don't seem to be able to find a supplier that does ether. So if you can help it needs to be in .223,model 415 ,AR with an 18 inch barrel.
I bought a Mitchells Lugar: the clips are very hard to load and the bullets stick in the cilps. Has any one delt with this kind of problen. The gun has hardly been used.
I am trying to help a widow sell here late husbands Gunsmithing equipment and I know very little about the stuff. Is there a special web site that would put her in touch with the people knowledgeable on values?
Would any one be interested in helping me identify 2 .12ga chokes I ended up with in a trade? I don't know how to put pictures up in this board but I do know how to take pictures and put them on my desktop. If you care to help e-mail me at : [email protected]
In the past I have used 308 brass for my 243 and necked it down with little problem. It has been a lot of years. As best as I can recall the only difference is I am using spray lub this time. I got one done but with a lot of effort and stuck it in the die twice. an suggestions?
I have heard of a 240 Savage or Stevens but never saw one. It is an over and under 410 break top w/ 2 hammers and the old nylon brown stock. This one in in about what I would call average for its age and it would be nice to have but I thought $499.00 was a little over the limit of nice to have...
I just purchased a NEF 280 and Redding dies that open up the throat of the 270 Brass. I have one round of 280 and it fits just fine and pops out when I open the breach. Now the 270 loads, seated the same as the factory seems to drop in just a little farther and doesn't pop out when I open the...
I would appreciate any information any one has on LIBERTY ARMS Here is what is on the barrel Liberty Arms Montiace CA Squires Bingham MFG " Liberty Sportsman" Made in the Philipenes Thanks Rj
A friend has a Old Muzzle loader. A Conesoga, Birds Eye Mapel stock, .32 caliber,2 triggers, Octigon barrel, last few inches if the barrel is (Sepigon 7)sided.
What can any tell us about it ? Where it came from and mabe the aproximate value.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.