Hi Guys,
Took the new Python to the range. She's been unfired since purchased in the 70's. A gentleman was selling off his collection and this is one of guns I purchased.
Ran some 180 gr. Hornady XTP's I loaded, and with just a couple of clicks left and a couple up, she's on at 25 yards...
Hello Wheelmen,
Just bought a couple new 6 shooters. A set of Ruger Blackhawks. I know they were pulled out of production in 1970 & 1971 but can't find anything else about them. One is a .357 and the other is a .41 . :banghead:
I've seen a bunch of commerative guns but these are new to...
Well a fine good evening everyone!
Have a new filly in the stable, a 1885 Uberti in 38-55. Have looked in my
books and have found very little on this round. The Hornady book shows one
jacketed, the Lyman shows one jacketed and 2 cast, nothing in Nosler.
Would like to try both types of...
Got a S&W 460. Been using .454 Casull loads cause I can't find the Hornady 200g. SST. Has anyone tried the Barnes 200g bullets made for the 460?
Thanks ........ Mike
Hello Everyone & Merry Christmas,
Looking for a .22 lr trimmer. Seen one in a magazine quite a while back. It was a small block that you would drop a round nosed .22 into and a
blade on a pivot pin would trim a small amount of lead off and make it a flat point. The article said they worked...
Ok guys,
I'm a pistol addit, and love to reload em'. Bought the S&W 460 (the 500 looked so alone in the case) but can't find the 200g Hornady SST's.
Have the dies, Starline has the brass, where the heck are those bullets?
Looked at Cabela's, Midway and Natches. Any Ideas?
Member...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.