Search results for query: *

jon, I found the following load to shoot ourstandingly well in my Rem. 700. Speer 115 HP #1617 IMR 4350 66.0 grains RP case WW Mag LR primer C.O.L. 3.150 inches Chronographed velocity 3279 fps avg. 3 shot group at 100 yds 0.3 inches Use this data to develop your own load...

La ccw I can help you with LA laws but need to know where in LA you will be relocating. Ranges, while not plentiful, are readily available. I shoot once per week at a couple of ranges nearby. grosland South Paradis, LA 25 clicks west or NO, LA

Thanks, Guys. I have made my own in EXCEL based on the one mentioned by BRUCE333. I would prefer to have it in a loose leaf format if that is permissible. grosland

I did the wood drilling bit and it worked fine. Had it fitted in a plastic bin with cover and all was fine until I exceded its capacity. The die plates fit exactly in the small 4 inch parts bins (don't remember the name of them). Now I have the ones I routinely use upside down along with...

What constitutes "bound" in the bound book requirements of a Curio and Relic license? Would a 3 ring binder suffice or does it really have to be permanently bound in the sense of a regular hard back book? Did you make your own or purchase it? Thanks in advance for any light you can...

I'm interested in a slide action rifle. I've seen some offered in 45 long colt. However, none of my data books list that round, only listing a 45 colt. Is there such a beast and if so what distinguishes it from the 45 colt? I've got 3 Speer, 3 hornady, 2 Hodgdon, 1 WW, and one IMR manuals...

After taking apart and cleaning my Rem 700 with synthetic stock, I had difficulty with closing the bolt if the front screw was tentiioned too tight. I wrote Remington a letter to ascertain the proper torquing procedure but all I got was a form letter that offered no real assistance. I...

I bought 1000 40 cal in the final throes of e-bay and with the shipment was a card with the following info: STAR Ammunithion, Inc. 5520 Rock Hampton Ct. Indianpolis, IN 46268 317-872-5840 I tried various url combos to find them online but to no avail. Hope this helps. I have used...

I also get great accuracy with the Rainier 148 DEWC behind 3.0 grains of TiteGroup. Have had no problems with keyholing and the load is relatively clean to shoot. I'm shooting them in a S&W 686 6" but my brother shoots them in his Rossi 4" with the same positive results. I just loaded a...

Thanks, guys. I'm using them for plinking / practice rounds and load in the low to mid range of the listed charge quantities. I just loaded some 9mm and will check them out next week. grosland.

I returned from my supplier this morning and discovered that I inadvertently purchased 2M Small Pistol Magnum Primers instead of reg. sm. pist. primers. What are the downsides of using these in 9mm, 38 Spcl. & 45 ACP? I do load some 357 & 44 Mag. but not nearly enough to use up this much in my...

If you were of a mind to store a bunch of ammo for future use, how much would you store and how would you store it? Would it be better to store powder, primer and projectiles and make it up fresh as needed or would you produce the ammo and store it? Thanks, grosland

At Harbor Freight Tools, I purchased a 2'x3' ruberized mat that is sold for lining tool box drawers for about $2. This mat makes a wonderful non-slip, non-maring surface on which to place guns and misc. on the range bench top. It's cheap, easily transported and well serves its purpose.