Search results for query: *

It's a LnL AP. I'll try turning the die down more.

It was always my understanding that you back the die off the shell plate 1/4 turn. Am I mistaken?

I've been reloading for a while but not in the last year or so. I set up my press for .223 using RCBS dies I had previously used without issue. I've got some processed brass from sharch and some unprocessed from who knows where, probably Wideners. The processed brass chambers in my AR but the...

I wouldn't have used them either except for the fact that a set came with the lower.

I just received a Spikes Gen ll billet lower, also known as the compressor. It's milled out to accept the KNS anti-rotation pins. I'm putting in a Geiselle SSA trigger and what do I find out? Geiselle says don't use the KNS pins on any of their triggers. Crap.

http://www.sinclairintl.com/.aspx/lid=16081/GunTechdetail/Setting-Up-Your-Full-Length-Sizing-Die This contradicts just about everything I've heard so far. Who's right? Or are both ways right?

What part of the hairspray actually does the trick? I'm fresh out with no wife around.

I just bought a Savage TR2 .22 and on the stock is a sticker that talks about their accu-trigger. Of course they didn't use a glue that allows for easy peeling and I can't get the darn thing to come off. It's a composite stock with a digital camo pattern and I don't know if a product like "goof...

I have the Lee, Hornady and Speer.

When do you guys do your trimming? After resizing or before?

A little bit right around the lower part of the shoulder all the way around.

OK. I just blackened two cartridges. One that chambers properly and one that doesn't. They both came out looking the same. I got my calipers out and measured every conceivable dimension and they all came out to within 1 or 2 thousandths of each other. I'm at a loss.

I do crimp with a Lee FCD but maybe I am crimping a little with the seating die. I'm going to try a sharpie and see what happens.

I've been reloading 5.56 for 7-8 years now and up till recently it's gone well. But now I can't get my recent reloads to chamber in any of my 5 AR's. The bolt won't close all the way and the rifle locks up to the point that I have to mortar it to get the cartridge out. It doesn't happen every...

Those are pretty good prices.

That sucks. I was going with a Rainier Arms Force Free Float System in 12". I really don't like the looks of a 15" rail on an 18" barrel but I don't want the gas block showing either. Guess it's the 15".

Will a 12" rail completely cover a low profile gas block on an 18" barrel with a rifle length gas system?

Of the powders listed in my Hornady manual I have Power Pistol and HS6. Either one of these better than the other for this bullet? thanks

God I hate getting old. There isn't any video on you tube showing the install of this rail so I didn't know that this rail comes apart in two halves. It's on now. Stupid, stupid, stupid.

I have this barrel nut http://www.bravocompanyusa.com/Barrel-Nut-AR15-p/barrel%20nut%20ar15.htm And this rail https://troyind.com/products/mrf-10-fde When I test fitted the nut to the rail prior to installing the nut it looked good. But now with the nut in place the rail won't slide in far...