I have a Pietta 1860 Army .44 and the R&D drop in cylinder I have will not fully cock. It will go to half cock but when I attempt to fully cock it, it will not go all the way back and it jams and will not go back to half cock. Any solutions?
I just got my R&D conversion cylinder in the mail and it fits right to my gun but when i go to cock it the cylinder dosent turn. When i put it on half cock the cylinder rotates fine but when i cock it all the way it starts to lock up and when the hammer goes all the way forward forget about...
I shot my pietta 1851 confederate model for the first time today. I only had time to shoot it once so after I shot it I cocked it so the cap would fall out and the cylinder would not rotate and when I looked I noticed some lead was stuck between the barrel and cylinder. Why did this happen and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.