Search results for query: *

need max and min powder charge data for .38 special,using 158 grain cast swc and universal powder.thanks

tried the plunk test on my browning hp 9mm.was using 356-125-25 cast bullets.plunked ok on my star b model at 1.125 aol.had to set to 1.090 to plunk in browning.anything longer than that and i can still push in a tad farther but seems like bullet is hitting the rifeling.am i getting to the point...

i have a .243 built on a 98 action.using masking tape it takes 3 layers before the bolt binds up.i have about 50 sized and primed cases.i know you can stretch these out without using bullets but cant remember what charge or what to hold the powder in with.have 4064 and some pistol...

i have a 22-250 with excessive headspace.whats the best way to load my cases to fit the chamber without using full loads?can i use full lenght dies to just neck size these cases after reforming them?thanks

im looking for .243 reduced loads.i have 100 grn. bullets and 4064,bullseye,reddot and universal clays powder.thanks

i just bought an alfred woodhill side by side-side lever in 10 guage.the only info i can find so far is that it was made in the 1870's.can anyone add to this? thanks...

just checked a few places and cant find micr-bed.whats up?

not to sure if it is spelled right but you know what it is.a friend of mine asked about it and its not in my book.he said he wants to load 150 grain bullets.anyone got any7 loads?

how fast can you run wheel weight bullets in .357 without leading? thats withoput gas checks. sid

which sizing die is best for .357 and .38.im guessing .359.

how do you cypher the top punch numbers in the lyman chart?

hi all, i just bought a 62 winchester.when you close the bolt it wont lock up.piece on the side of the bolt that releases the slide still has a square edge.i havent pulled the tube yet to take the slide off to get a better look at the notch on the end of the slide.is this most likely...

i think i have a headspace problem with my 7 mag.im getting case seperation ahead of the belt and its hard to open the bolt.i got some virgin brass to reload.can i put 10 grains reddot,some filler and then wadding to fireform mycases.then can i set my die to headspace on the shoulder instead of...

looking for forums for the star bm.anyone know of any? THANKS

looking for good forums f or the star bm.has anyone run across any?

i have an h&r 949.when you cock it the cylinder wont rotate.the hand works just just fine with the cyclinder out.tried a new hand and same problem.can anyone help?

i have an old h&r 949 revolver.when you pull the trigger the cylinder wont turn.the hand comes out but wont ratchet the cylinder.the spring is still in the hand.any suggestions?tried a new hand and still the same thing.

first post on this forum so hi to everyone.i got a new paw from Ruger for my new model .45 colt blackhawk a couple days ago and made it free spin.the cylinder latch drops out just long enough for the cylinder to start to turn then drops back in and drags to the next latch.how can i make it not...