Search results for query: *

  1. S

    Frangible Load data

    Does anyone have any load data for the M-160 108.5 gr frangible projectile in .308/7.62? These can be obtained pretty reasonably, but I cannot seem to find any load data for them. Any help would be greatly appreciated
  2. S

    Max case length for .50 BMG?

    A lot of the guides show 3.91,,,,,not sure if that is suggested length or max length. I resized some once fired MilSurp LC brass and am getting readings of 3.945 average. In the whole scheme of things, how far can one deviate from the 3.91? If I need to trim....no big deal...but if anyone...
  3. S

    Max case length for .50 BMG?

    Does anyone know what the max case length is for the .50 BMG? I am not looking fo overall length, but the length of just the case.
  4. S

    Projectile weight and powder weight correlation

    Thanks. I am more interested in the Flash/Bang at the point of impact than the tracer effect, but I will keep that in mind. Thanks! Another Q; is it imperitive to resize surplus projectiles before reloading?
  5. S

    Projectile weight and powder weight correlation

    Steve4102 - rest assured that I do not load by rule of thumb. I was looking to spark conversation with anyone who has loaded .50 BMG. RecoilRob - I am talking about the Spotter-Tracers. Can you recommend loads using the WC-860 powder? I have the Military loading data and it shows WC-860...
  6. S

    Projectile weight and powder weight correlation

    Looking to reload .50 BMG for "plinking" Can get a good deal on some mil surp components locally. the projectiles that I am looking to use are 800+ gn as compared to 690 gn for usual ball rounds. I cannot find any load data for a round this heavy. Should amount of powder decrease with the...
  7. S

    .50 BMG for sale??

    Anyone know of a .50 BMG for sale? Particularly looking for an ALS-50 (Advanced Long-range Systems).
  8. S

    F A L ?

    I am feeding my FAL with reloads. I get the components from Hi-tech ammo (out of St Louis, Mo) and assemble myself. Ends up being about $0.20/round.
  9. S

    FAL: Inch vs Metric

    Any clue where I can get a complete metric lower for around $100?
  10. S

    FAL: Inch vs Metric

    Does any one know if the same furniture can be used on an inch pattern FAL that can be used on a metric? Namely the buttstock, I am looking to get a SAW stock for my inch FAL, but the only ones I can find are for metric applications only. Don't wnat to spend the money if it won't work!
Back
Top