Search results for query: *

  • Users: Globeguy
  • Content: Threads
  • Order by date
  1. G

    Tantal rear sight elevation adjustment blocks the rear sight's slot!

    I just picked up a tantal, and its rear sight elevation adjustment block actually blocks the little notch in the rear sight. Are Tantals suppose to be this way?!??! :what:
  2. G

    Hornady decap die

    My decap die's spindle lock must have been a little loose, I saw that decap pin was rising after awhile. I went to loosen the spindle lock, adjusted the decap pin's length back to 3/16" then tightened the spindle lock again. Only to find that my pin was freely spinning, instead of tightly held...
  3. G

    Bought a Hornady LnL press and new dimension dies

    Hello, I'm a long time lurker and a first time poster. It looks like THR has a number of LnL AP owners so I thought I seek your help. I have my crimping die setup on my 5th station for 9mm. The problem is I can't get the die to crimp my 9mm shell unless I thread the die through the press...
Back
Top