Search results for query: *

I just purchased 8 lbs. of W231 powder for loading .45acp. Hopefully I live long enough to use it all.

Net bag not "new" bag. Typo.

I use it. It will remove the grime from the cases but will not make the cases looking like new brass. After using the losso, with cases in a net bag, I place the net bag with cases into warm water with Dawn dish detergent and slide the cases back and forth inside the new bag. Finally, rinse with...

Will they work in a Marlin 39 A lever action.

I use Sierra 130 gr. Match Kings in two 7mm-08s. They kill deer just fine.

uncleunzie: my path with the Tisas Carry was similar to yours. First thing to go was the ambi safety. Installed a Ruger TS. It also now sports a Chip McCormick trigger from a pre-series II Kimber, a Harrison Design hammer/strut/pin, EGW sear, Wolff 18lb recoil spring and firing pin spring, and...

Rattlesnakes: don't like them and never will.

I have the older version. It is the only press that I own. The largest caliber I used it on was a .300 RUM (before I got rid of it). You need to be creative for the larger cases and case + bullet. If I recall correctly for the RUM I had to insert the case into the shell holder then partially...

Rem. 760 with 150 gr. sp has worked well for me on whitetails.

Approximately, 43 years ago I had a gunsmith lighten the trigger pull on my 39A Golden. He got the pull down to about 8 lbs. I then installed a reduced power hammer spring. That got the pull down to about 7 lbs. Finally, I broke it down and stoned the sear and hammer. Pull weight is down to...

I have the Pacific Canvas and Leather M7 for 1911 carry when backpacking/hiking. I like it but in tan. The tan model is not dyed. Sweat and a good leather conditioner gives it the brown color.

Make sure the front action screw isn't a hair too long.

I use Goex 2F but I run a spit patch down before reloading. Seems to help.

I load Sierra 85 grain hpbt with IMR 4831.

I use Varget as powder in two 7mm-08s. I do not have your rifle but I load Sierra 130 gr. HPBT Matchkings in both rifles.

It appears you have resolved the problem. A too long front receiver bolt will cause a bolt closure issue also. Resolved with a file to shorten the bolt.

The Timney Rem. 700 trigger is wider than the old stock 700 trigger - I don't know about the X Mark Pro. You may have to rasp or dremel a minor amount of stock at the front of the trigger housing to get the Timney front weight of pull screw & nut to fit. The last Timney I bought has the...

Mine is .222. A little bedding done and timney trigger. First centerfire rifle I purchased and my favorite.