Search results for query: *

so how is it that the new NY mag "laws" are not in violation of ExPost Facto? Simply because they have a time limit to get "rid" of their 10 rd mags which they previously purchased legally?

I have a failure to feed on my Winchester 1897 Takedown pump The round goes sideways slightly instead of straight into the chamber. Is there supposed to be some sort of guard that slides up to prevent this from happening? I see there is a thin steel fence/blade that slides up and down...

deer rub? Is that a giant deer rub on that tree?

In a 16" barrel AR platform, I have used 1/9 and 1/7 The 1/9 group with anything heavier than 62gr would open up to 3" or more. With the 1/7 I got tighter groups with a wider range of ammunition. One upper had a definite preference for 68gr with .3" groups at 50 yards with 2moa red dot and...

Hello Congrats on making the show and welcome to THR.

hi I think midway has a ring height chart check them out

yeah just whisper in his ear...

that looks like a free float rail - is it? or is it a KAC RIS/RAS (or similar) system?

large rifle primers showed up recently

I have tried the Chrony brand - was not impressed and returned it lots of errors, poor quality Am now using this: http://www.competitionelectronics.com/pages/Prochrono_Digital.html Good price, dependable, nice features

yep - 22 cal can be 223... or the reporter/s could have simply been wrong could have been a .27 caliber rifle ( .270 ) and that would definitely drop nearly anything in the lower 48 states I always tell folks I only have a .22 rifle...

lots of stripped lowers available at near pre-panic prices lots of of LPK prices coming down lots of complete NIB never fired second hand AR's available

here in jax, the ammo shortage has decreased range use a few months ago, it was mostly 22 LR shooters now that 22lr has dried up, those are gone too but last vist, since a gun show was in town, there were a bit more but not as many as late last year

ok - so it works fine with factory rounds for extraction of a non-fired round where to get a small-based sizing die and how is that different from a full-length resizing die? so now, the forward assist problem. I'll send them an email about it and see what they say. to be continued

but from where?

so how does it shoot in comparison to the stock barrel?

FYI found out that Del-ton uses a commercial tube on the standard 6 position stock

tried running the die down further and I trimmed, sized the next batch of cases with the possum hollow .223 case trimmer and used the hornady deburring tool on each case don't have my notes in front of me so will have to update the case length later Still have sticky extraction...had...

what kind of problems did you have?

how much shorter did you trim?