Search results for query: *

joed, I'm doing that with 9mm and small primers too but I have the case feeder as well. I also use a non-Dillon bearing under the shellplate to prevent powder spilling and bullet falling, it is made by Hit Factor Shooting Supply and really worth the 10$. I also check my brass and lube it...

- jmorris, could you adapt your system with different calibers, I use it for 9mm & 45ACP ?

- Soleman, it's made out of 2 x 6 with a glued arborite sheet over it

thanks, now I can do 1200 rounds per hour with 10 primer tubes filled, I used to do 700 without it

Hey guys ! I finally finished the installation of a Hornady Bullet Feeder on my XL650 and thought it may interest some of you. Things to know: 1- The supplied support is not high enough if you have the Dillon strong mount, I found 2 options: a) You can put a 3/8" metal plate between...

BlueDot 10,2GR - Rem 158GR JSP - OAL 1,592" - 1222 FPS - 17,2 SD - 2,121" @ 15yd - 1,50" @ 10yd

W231 & vv3n37

Hi Going to Pittsburgh in a week or 2 and need a CZ Kadet Conversion Kit Is there a shop or 2 that I can get it ? Thanks Snowboy

if you can give me feedback on how it's going & suggested improvement (for those I sent it to) Rodg

Just to have an idea of how many of us are or aren't doing it Just saw Brian Eno's DVD on reloading and he says he's doing it but I've read so many posts saying it's dangerous

Maybe you can find a buddy who own an Office 2003 Pro CD that fit in your computer ;-)

Here's my "survival kit", CZ SP-01 Shadow + S&W 686-3 6"

Please email me for it (no PM) cause it's a little hard to manage email addresses from the PM Window I received a lot more requests than I expected so it will be easier for me to have every request answered by email ;-) Thanks [email protected]

mod done, thanks for the input

Hi everybody A little free goody here: I made an application based on MS Access to compile loads and produce reports by caliber, bullet, powder, etc and I thought it would be a good idea to share it with you guys You simply enter the data of your loads (pix #2) and some reports can be...

I just sort my brass by lenght and adjust the dies to seat the bullet as I want it when I change from a lot to another

I have one but to be honest I use it only to see which way goes more or less,,, tried to use it at first but for me it was to much trouble for the little time saved considering the fast adjustment I can make with an electronic scale on my other powder measure I put a 3$ plastic button and...

I change the corn a way sooner than 30K rounds... I pay it $20 for 50 pounds so I don't try to extend its life... but I'll take your advice and check it once in a while

didn't have any problem yet, got about 2000 rds that way, when corn is not smelling NuFinish, I had another capful and it's like every 3-4 times. I put 3-400 cases (9mm & 357) at a time

I put a capful every 3-4 tumble and it works great with corn media