Search results for query: *

My kinetic puller causes tip elongation Many times when using my kinetic puller I find that the tip--either lead or polymer--is elongated (slightly pulled from bullet) sometimes. Happens most often when I have to hit the concrete floor more than two-three times. These are rifle cartridges that...

My kinetic puller causes tip elongation Many times when using my kinetic puller I find that the tip--either lead or polymer--of the bullet is elongated (slightly pulled from bullet) sometimes. This happens most often when I have to hit the concrete floor more than two-three times. These are...

Use of REAL bullets Hi Rodwha--I will be using these bullets in a TC Hawken (1:48) and a Lyman Great Plains Rifle (1:60 or 1:66, don't recall which at this moment). Both these rifles stabilize the 385 gr buffalo bullet out to 100 yards (my max range), both stabilize the 250 grain Lee REAL...

Thanks rodwha Thanks rodwha for replying to my message. I appreciate your help. I've been in contact with DD and am planning to purchase some bullets from him. Jayhawk Dan

If anyone here knows of a commercial source for .50 cal Lee REAL bullets, please share it with me!:) I know I can purchase the molds and cast these bullets, but I really don't want to get into casting. Also, I've searched this forum and haven't found a source, but if there is a posting/thread...

Read a reloading manual!!!!! DON'T do any reloading, Dudemeister, until you've obtained and read a reloading manual for reloading the .30 WCF (.30-30) cartridge!! :uhoh: This is a fundamental step in reloading safely! Jayhawk Dan

Thank you! :) Thanks to everyone who replied to my question on this topic! It was good of you to offer your knowledge, experience, advice, and suggestions; all have been very helpful to me. I think that as of right now I have enough information to proceed. If I run into unforeseen...

Little help here please!:confused: I want to convert .30-06 brass to form 8x57 Mauser brass, and I need some specific directions--a recipe?--on how to do this. Would someone please give me the directions to do this or direct me to a source for this information? I am an experienced...