Search results for query: *

Very pleased with my CompTac Minotaur MTAC Hybrid IWB. Comfortable all day with a reasonably good belt.

Depending on her schedule, she either carries a SIG P238 or, preferably, an S&W M&P9C. I also typically carry a carbon-copy M&P9C as an EDC, but swap for a BodyGuard .380 occasionally.

This is absolutely a personal decision, and a serious one, so I will not try to convince. Here are some considerations that weighed into my decision. 1. There are very real threats to my personal safety (as well as that of my loved ones). 2. Many, BUT NOT ALL, threats can be avoided. 3. I...

The 325PD I have is a round but. I believe the NGs I have seen are too. It is indeed an N frame.

Follow-up: The first week of March, I finally sent the revolver back to Smith&Wesson. I got the return shipment one month later. Inside, the note that came back indicated that they had replaced the entire frame and destroyed the old one. Upon inspection, I suspect that they replaced the...

Most definitely not a new rifle or new cartridges, but the Savage Model 99 was chambered in .308,.243,.250-3000,.300 Savage, and a few others, I think. Ballistically, some of these seem to cover the spectrum the OP was interested in. Russ

I am glad the mule and the OP both came out OK. It would have been a shame if the dogs had hurt RidgeRunner's mule, but I think they ended up as they deserved. I wish our miniature donkey was a bit more aggressive toward interlopers in the pasture and less so with the other animals that are...

Again, Thank you everyone. I took another look late last evening at the protrusion of the firing pin with the trigger fully pulled and also by manually pushing on it. Compared to an old model 10-5, the firing pin seems to only protrude about half as far. I am thinking a new firing pin is in...

Thanks for the insights, everyone. FWIW, I was using clips for each cylinder full and still had the failures to fire. Also, I got the revolver at a gun show NIB, but of course could not go over it with a fine toothed comb. I am a bit disappointed at the amount of "shake" when the cylinder...

I recently purchased a model 325 PD and have only been to the range once with it. It was a pleasure to shoot, but I had an issue -- at least one failure to fire in each cylinder using Blazer (aluminum). Additionally, bullets were noticably pulling from the cases before the complete cylinder...