Search results for query: *

Wife and I had a confrontation with a undesirable the other day. Had a guy and gal almost run into my wife and I from the rear. I pulled out on a empty city street, and before I even got up to the speed limit this guy almost rear ended me! Flashed his lights and horn, and shaking his fist at...

Shot a flying mallard hen out of the air around 60 or 70 yards away, with a flintlock rifle. Man what a puff of feathers, there wasn't even enough left to eat!

Antelope weight is only about 110 lbs for the biggest one I ever weighed. I have shot a lot with muzzleloaders, the closest one was 15 feet! I could see his eye dialate when I raised up and shot him. It doesn't take any special ctg. to kill one. Just stalk close and shoot. Thats all that is...

I saw my wife shoot a 38 cal. flintlock at an ax blade, severed the ball and broke a couple of clay birds on each side of the ax. This was in a compatation shoot! The toolman.

brass I was at a range with my son one time a couple of years ago. While he was shooting I sat on a chair behind him to watch. A young couple was shooting in the left lane next to me, and her husband was explaining how to safely handle and shoot a 40 cal pistol. She was rather well endowed...

My best ever was a free Japanese sword, made in the 1800's. Stright from the man that captured it. The toolman.

When you finish those, look for the six books on man eaters by Jim Corbett!!!!

brass I too had this happen to me! I finely found that my brass, once fired beore I purchased it, had been annealed. It was so soft in the head, that reduced loads would cause the same kind of primer pocket swelling as your pictures. You didn't anneal them by any chance did you? I finely...

self defence I can think of two time in my life where I used a gun to keep from being injured. The first time I was about twelve, I was walking along a country lane with my 20 gauge shotgun going duck hunting. A car came up behind me at a high rate of speed, and crossed the road to hit me...

primer catcher I just made one up for a Lyman Spar-T press the other day. Used a piece of 1/2 brass tube with a lub soldered on to it to fit the priming arm hole. Had to do a lot of cutting and bending, but it works a treat. Drops the primers into a Russian oil bottle that I had. John the...

GP problem My pistol had the same problem. I found the cast bullets were impinging on the forcing cone in the front of the chamber. I just seated the bullets a bit deeper and no problems since. The toolman.

Front sight I would find someone with a small tig welder, and weld a bit of stainless weld rod to the top of the sight. Reconture the sight while sighting it in. Just did the same job on a SS S&W that was shooting to high. Can't even see that it was done. The toolman