Hello
I hope I am posting this in the proper place. if not, please direct me and I will repost.
I recently purchased some 200gr plated round nose bullets from Everglades Ammo. Do any of you guys have any experience with these? I have never loaded a plated bullet but have read to load for cast...
I tried my first 50ae reloads in my new Desert Eagle L5 (Light weight 5" barrel). I took 18 handloaded rounds to the range. 300gr Berry's in Hornady brass with CCI 350 magnum pistol primers:
6 rnds @ 30.5 grains H110
6 rnds @ 31.5 grains H110
6 rnds @ 32.5 grains H110
With some of the 30.5...
I just did some 32 SW reloads for plinking use in my 32 conversion cylinder I was reloading with BP
so feel its more applicable here than in the reload section.
I posted this vid here about 7 years ago and had mostly positive comments except for my
handling of capped cylinders outside of the gun.:what:
Many people asked how I was able to keep exchanging cylinders because anybody that owns one probably had cylinder jam problems.here is my answer to...
Hi all,
Recently entered the world of reloading with a Lee Hand Press to "learn the ropes" - so far, I'm exclusively loading .38 special, with plans to soon move to .357 magnum. My first load was 3.4 gr of Bullseye with a Hornady 158 gr LSWCHP in Remington brass. The OAL is slightly under 1.5"...
I was reading the thread about the 7.62x39 bolt action carbine and then I realized how long
it has been since I have reloaded and shot that round and that I might convert a barrel I have to use with a new universal system I fabricated.
I have decided to post this project here so others in the...
I got some cheap Tula ammo for my birthday. I don't normally buy the stuff but I sure did shoot it :) Anyway the ammo was steel cased ...can these be reloaded? If so is there anything special one would need to know about reloading them?
I recently acquired a .44 magnum with a 3.75 inch barrel. I've been doing lots of reloading research to find a tame load for quicker target reacquisition, and just wondered what anyone thought? Have a good load I should check out? Thanks.
Hello all,
I'm new here, and new to reloading so advice would be most appreciated. I recently started reloading for my A.R. 15 and after some research, and some suggestions people are saying do not crimp for best accuracy but rely on the proper neck tension contacting the bullet. High power and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.